Also note that ip routes added in this manner will not persist after a system
reset. The correct way to add a static route is via the ip-route profile.
new ip-route whatever
list
set destination-address = #.#.#.#/24
set gateway = #.#.#.#
write
see page 382 of the APX/TNT/DSLTNT Reference Guide part number 7820-0805-002. If
you don't have this document go to www.esight.com and download it from there. It
should also be available at ftp.ascend.com
Jukka Pakkanen wrote:
> > > At any rate, when using the iproute command <iproute add #.#.#.#/24
> > > #.#.#.#/# 1> I get the error "Warning: the route was NOT added.".
> > > Does anyone have a brief explanation of why, or point me to the docs
> > > that would explain why? The ascend documentation is fairly sparse
> > > on this matter. Any help would be...most.....helpful.
> >
> > Put the gateway address without network size parameter, because you
> > are not routing to a network, but to a gateway. iproute add #.#.#.#/24
> > #.#.#.# 1
>
> Actually, just tested and it does accept the size parameter.. so there must
> be something wrong with the destination or gateway addresses. Check
> that the gateway address is valid (MAXTNT should know the address,
> otherwise it'll not accept the route).
>
> --
> /} Jukka Pakkanen, Q-Net
> @#####{ ]::::::::::::::::::::::::::::::::::::::::::::::::>
> \}
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request at bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
--
=====================================================================
Rich Chiuve
Senior Systems Engineer
Lucent Technologies phone:781-331-3849
Internetworking Systems Fax:781-331-6399
Service Provider Sales email:rchiuve at lucent.com
=====================================================================
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request at bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>