Hi all, Anyone out there familiar with any problems which exist with Pipeline 50 units which cause them to just start generating large amounts of CRC errors, then losing connection (ISDN)? I'm using these units creating a WAN between two offices. I've looked at everything! I've ordered several line quality tests on the ISDN lines, all the way to my equipment. Should I trust the ISDN vendor (ma bell)?, I'm assuming I do. I've looked at network traffic, nothing on either side is causing CRC's, as I've isolated all hosts off each LAN. I've looked at ALL configuration settings, and tried ALL different scenarios of bridging, and routing. Almost always, when I reset both units (cycle power for 20sec's+), they connect up fine for x-amount of time (varying between 15min's and two weeks of error free uptime). Much more to tell, I'll spare the details, I've spent a lot of time trying to solve this problem - Anyone with similar experiences, advice, clues??? ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/