Hi Eric, Have you tried reloading the code with the new card in the chassis? Try this if you haven't and the card should come up normally. Regards, David Pascarella, MCSE CCNA A+ Network Support Engineer SOLUNET, Inc. 1571 Robert J. Conlan Blvd., Suite 110 Palm Bay, FL 32905-3562 888.449.5766 800.795.2814 fax: 321.308.7986 mailto:dpascarella at solunet.com -----Original Message----- From: Eric Larsen [mailto:eric at istal.com] Sent: Monday, May 21, 2001 2:47 PM To: Ascend-Users Subject: (ASCEND) TNT trouble with ethernet-2 card I put a new TNT-SL-E-10-100 card in my TNT , software v. 8.03, and the fault light came on. I deinstalled the old card using the remove command before loading the new card. Anyone know how to troubleshoot this , or the steps to load a new ethernet-2 card. Eric eric at istal.com ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/