that sounds good, but i also have a max 3000 in the mix too, and that code version doesn't go that low. is it possible to run the max 3000 at a higher taos version and still have mpp working? duane ----- Original Message ----- From: <MPuras at solunet.com> To: <duane at coxnetwork.com>; <ascend-users at bungi.com> Sent: Monday, May 21, 2001 1:24 PM Subject: RE: (ASCEND) max 4000 trouble Duane, The 4000 is obsolete and no longer supported. The code of choice from what I have seen is 7.0.22 on the max 6000 which runs the same code as the 4000. In order to do stacking just go into ethernet-->mod config--->stack options and enable it. Give a common name that all must share and that is it nothing else changes. Hope this helps! Mario Puras SoluNet Technical Support Network Support Engineer We don't make network products, we make them Work! Mailto:mpuras at solunet.com 888.SOLUNET (Canada) / 888.449.5766 (USA) -----Original Message----- From: Duane Cox [mailto:duane at coxnetwork.com] Sent: Monday, May 21, 2001 1:48 PM To: ascend-users at bungi.com Subject: (ASCEND) max 4000 trouble I have a max 4000 with taos 7.0.26 It is having modem problems, a reboot fixes them (isn't that typical with TAOS) and also disconnect problems What version is everyone else running, and why the heck isn't ascend/lucent producing new code for this product. We also have 6000's and 3000's, and I really need to get the stack option to work for MPPP , what can I do?? Duane Cox dcox at illicom.net Archives: http://www.nexial.com/mailinglists/ Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/