Assuming that you have correctly installed and configured the ether2 card......... 1. Try setting the SCM ether port to 'management only' 2. Check your IP addressing and make sure you are not trying to route out that interface. 3. Disable it and try the netstat again. You may be seeing the sys IP address, also. David Pascarella, MCSE CCNA A+ Network Support Engineer SOLUNET, Inc. 1571 Robert J. Conlan Blvd., Suite 110 Palm Bay, FL 32905-3562 888.449.5766 800.795.2814 fax: 321.308.7986 mailto:dpascarella at solunet.com -----Original Message----- From: Eric Larsen [mailto:eric at istal.com] Sent: Wednesday, May 23, 2001 7:31 AM To: ascend-users at max.bungi.com Subject: (ASCEND) directing traffic over new ethernet card Does anyone know how to redirect traffic out over an ethernet-2 card rather than letting it go out through the shelf contoller. I put in a new ethernet-2 card, however, a netstat -i indicates that all data is still going through the ethernet port on the shelf contoller card. Any advice on how to fix this would be appreciated. Eric Larsen IST, Inc. ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/