I recently went through the same changeover. I'm not sure I can tell you everything you have to do, but I can mention a few things. Go to the configuration for each T1, i.e. Net/T1-->Line Config-->** Factory-->Line 1 1. Set Signal Mode to ISDN 2. Check Framing Mode and Encoding. These most likely will need to be set to ESF and B8ZS respectively. 3. Make sure all channels are mapped to slot 0. This is a gotcha that got me in the switchover. I had all channels mapped to slot 3 and this worked just fine for dialup. But it would not let ISDN connect. Hopefully this will help some. Dennis Duval ----- Original Message ----- From: "John Kern" <psc5 at powersupply.net> To: <ascend-users at max.bungi.com> Sent: Friday, July 05, 2002 12:26 PM Subject: (ASCEND) Setting up Dialup and ISDN on PRI > We are currently running MAX 4K and 6K units with CH T1's. > > We are in the process of switching everything over to PRI's. > > What changes do I need to make in the MAX units? > How do I config PRI? > > I am lost. > Need to get these working ASAP. > > Thanks, > Johne > > ++ Ascend Users Mailing List ++ > To unsubscribe: send unsubscribe to ascend-users-request at bungi.com > Archives: http://www.nexial.com/mailinglists/ > ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/