> Hello > > I was upgrading the ram in our Max3000 hardware, while I had 2 of them = > on the shelf, I also noticed a battery on the motherboard. After I = > replaced the RAM and checked the status to make sure it came up ok, I = > proceded to power down the unit and replace the battery. Now I am = > stuck, and finding help one a lucend/ascend site is a joke, and calling = > for support per minute is as well. ( I was on the phone for 10 minutes, = > and all she wanted to know was my address and then proceded to tell me = > she didn't know what to do or what I was talking about...) Anyway, I = > finally got an email forwarded from another tech, that said to put the = > unit into nindy mode. Well I shorted out the nindy pin, but I still get = > nothing. I hook up my serial connection at 9600 8-n-1 no flow control, = > and get NOTHTING on the terminal, not even the bootrom, even in nindy = > mode, nothing. All I did was replace the battery. There has to be an = > answer for this other than sending it in, or every person in the world = > that has a max 3000 will have to send it in, in 5 or 6 years when the = > battery dies anyway. > Any suggestions? > > Duane Cox > dcox at illicom.net ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/