Try using a connection profile, without the radius, to simplify the scenary, -- Gustavo Villate R&D Consultant ConeXion S.A. gustavo.villate at conexiongroup.com (595) 21 440104 (595) 981 417436 ----- Original Message ----- From: "Administrator" <WebMAster at gcstation.net> To: "Mustafa F. Rana" <mfrana at cyber.net.pk>; <rte-ascend at lists.real-time.com> Sent: Monday, July 29, 2002 3:20 PM Subject: RE: [Ascend] MAX6000 config help > I went under answer->ppp-> and tried both and pap and nether one had > any effect on it... I am running cistron radius 1.6.6 on a linux and > the software on the Ascend Max 6000 is 8.0.3+ > > Anyone else have any ideas what I might try? When watching the Max box, > I see the client trying to connect because I see the caller ID info. > > I don't have any skills yet on any debug features of this box so I would > welcome any suggested command to try to track it from that end as well. > > Thanks again, > Mike > > > > > > -----Original Message----- > From: rte-ascend-admin at lists.real-time.com > [mailto:rte-ascend-admin at lists.real-time.com]On Behalf Of Mustafa F. > Rana > Sent: Monday, July 29, 2002 1:45 AM > To: WebMaster at gcstation.net; rte-ascend at lists.real-time.com > Subject: Re: [Ascend] MAX6000 config help > > > Try > > PPP Auth = PAP (In most cases with Cisco it works) > Also mention which TAOS you are using. > > Regards > Mustafa > > ----- Original Message ----- > From: "Administrator" <WebMaster at GCStation.net> > To: <rte-ascend at lists.real-time.com> > Sent: Monday, July 29, 2002 7:54 PM > Subject: [Ascend] MAX6000 config help > > > > Greetings all, > > > > New user to MAX 6000 and I am having small problem. > > I have been using a pm3 without problems. I "inherited" a MAX 6000. > > I configured everything, I thought, correctly. I am using a radius server, > > if that matters. > > > > I set it all up to be able to just unplug the PM3 and plug in the Max. > > > > When I do, everyone but 1 customer works flawlessly ! > > > > The one customer who fails is using ISDN, both channels and is dialing in > > with an 800 series Cisco. > > That customer usually fails completely, I have seen in the radius > accounting > > where it does connect > > for seconds and then drops saying it was terminated at his end. > > > > Can anyone give me an idea what to look for ? > > > > Thanks in advance, > > > > Mike > > > > _______________________________________________ > rte-ascend mailing list > rte-ascend at lists.real-time.com > https://mailman.real-time.com/mailman/listinfo/rte-ascend > > _______________________________________________ > rte-ascend mailing list > rte-ascend at lists.real-time.com > https://mailman.real-time.com/mailman/listinfo/rte-ascend >