When i hit the uptime -a command i get the following: { shelf-1 slot-1 } 4ether-card 0 days 00:15:16 7.2.4 { shelf-1 slot-2 } 8t1-card 0 days 01:00:07 9.0.0 { shelf-1 slot-3 } 8t1-card 0 days 01:00:07 9.0.0 { shelf-1 slot-4 } csm3v-card 0 days 00:57:55 9.0.0 { shelf-1 slot-5 } csm3v-card 0 days 00:57:55 9.0.0 { shelf-1 slot-6 } csm3v-card 0 days 00:57:55 9.0.0 { shelf-1 slot-7 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-8 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-9 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-10 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-11 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-12 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-13 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-14 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-15 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 slot-16 } csm3v-card 0 days 00:57:54 9.0.0 { shelf-1 controller } shelf-controller 0 days 01:01:06 9.0.0 I'm currently running TAOS version 9.0-159.0 and there is no "driver" for that card. I found that version 7.2.4 has it so I loaded the enet "driver". When I use the sh command i get the following: { shelf-1 slot-1 0 } UP UP 4ether-card But when the card boots up it says this: LOG alert, Shelf 1, Slot 1, Time: 11:09:18-- Could not create IP-INTERFACE profile for { 1 1 5 } LOG alert, Shelf 1, Slot 1, Time: 11:09:18-- Could not create ETHERNET profile for { 1 1 5 } LOG alert, Shelf 1, Slot 1, Time: 11:09:18-- Could not create IPX-INTERFACE profile for { 1 1 5 } and if I assign an ip to any of the ethernet interfaces that show on ip-int, it doesn't respond. What could be wrong, or what could be the fix? Thanks Jose Escobar jescobar at ayustar.com ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/