Hi Joe, Have you noticed any fatal errors in the history log since you upgraded. Also, you may want to run a syslog server for the MAX and see what pops up in there. It sounds like a software/hardware error that is hijacking CPU processes. Sometimes, when this happens, you will see a fatal 1 or 2 in the history log. If you DO see those specific errors, I'd recommend reloading your current TAOS rev. or upgrading to a 9.0.x. Even if all else fails, you may want to upgrade, anyway as a last resort. It may not be an issue with that specific code rev, but rather that it is somehow corrupted and is causing problems. Have Fun, - David -----Original Message----- From: Joe Hamby [mailto:johamby at blomand.net] Sent: Friday, September 13, 2002 10:56 AM To: rte-ascend at lists.real-time.com Subject: [Ascend] Max 6000 upgrade problem I have a Max 6000 that has been running on software 7.0.3 with no problems that I am aware of. I recently upgraded it to software version 8.0.4. As soon as it finished rebooting after the software upgrade the box is slow to respond in either a Telnet session or directly connected to the Console port. The box is used only for dial-up RAS. If the incoming trunk lines are disconnected or disabled then it seems to respond fine but connecting even one single T-1 back to the box makes the box almost unresponsive once traffic starts hitting it. I have compared the config line by line to another box with the same software load that is performing fine. The are identical. Has anyone seen this issue before? Thank You. Joe Hamby Ben Lomand Internet _______________________________________________ rte-ascend mailing list rte-ascend at lists.real-time.com https://mailman.real-time.com/mailman/listinfo/rte-ascend