Try either assigning a phone number to each ds0 on the PSTN lines (T1 profile), or create call-routes (type trunk-call) with the phone number set for each PSTN line. Incoming calls from the PBX can then "dial" these numbers to connect to these DS0s. One or both of the above should work. -J >I have a TNT with a DS3 to the PSTN and a T1/PRI to my PBX. Inbound >calling works like a champ with a few simple call-routes, but for the >life of me, I can't figure out how to get the TNT to properly route >calls from my PBX to the PSTN. > >I've played with 'Preferred-Source' and 'Trunk-Group' values in the call >routes, but had no luck. > >About the only thing left I can think to try, is to change the default >call routes to go out the PSTN instead of the DSP cards, then create >call routes to route incoming modem/ISDN calls back to the DSPs. > >This is all with TAOS 9.0.9. > >Can anyone shed some light on this subject? _________________________________________________________________ Get MSN 8 and help protect your children with advanced parental controls. http://join.msn.com/?page=features/parental ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/