Thanks to those of you who have responded to my problem. It turns out that support for the BusLogic BT-946C is included with RedHat 6.2. I found the Bus_Logic.o module already on my system. My PC just would not boot with the SCSI card in it though. After monkeying around in my BIOS I just decided to try resetting the BIOS the to default seetings and that seemed to do the trick. After rebooting LILO came up and away I went. Kudzu detected the SCSI card and said it configured it. I tried to run a few commands out of a document I was directed to from a tech. support engineer at HP and they eventually worked. I have been instructed to take the homemade backup shell script that someone at my company had previously written for an HP-UX system and make that work. It is using cpio. So that is where I am at. I just need to tweak that some and it should take care of me. I am still going to get hold of the O'Reilly book however. I think there is probably a lot I could learn from it. Mike --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org