Ummm... If it's PCI, it's probably one of the infamous WinModems. You could try looking about on http://www.linmodems.org/, but don't get your hopes up. On Sun, 2001-12-16 at 18:04, Perry Hoekstra wrote: > I have a question on modem detection. I installed a modem on a RH7.2 > system. Upon bootup, Kudzu detected the modem and configured the > modem. If I do a lspci, I see the modem in the listing. How do I > figure out which /dev/ttyS* it is parked on. I have going through the > Linux Modem-HOWTO. I tried probing using setserial but all it tells me > is that I have UART 16550A on ttyS0, ttyS1 and unknown on ttyS2 and > ttyS3. Is there a file that Kudzu wrote the configuration to or when > setserial is run on startup? I looked in the standard places such as > serial.conf but there was no joy. > > -- > Perry Hoekstra > E-Commerce Architect > Talent Software Services > perry.hoekstra at talentemail.com > > > _______________________________________________ > Twin Cities Linux Users Group Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >