Ebay. http://makeashorterlink.com/?M4A623871 Tom Veldhouse ----- Original Message ----- From: "Simeon Johnston" <simeonuj at indivisuallearning.com> To: <tclug-list at mn-linux.org> Sent: Thursday, August 08, 2002 8:41 AM Subject: Re: [TCLUG] So *can* you use PC133 memory in a PC100 system? > EDO/FPM is NOT PC*. They are not/have never been compatible as far as I > know. > There was one board I worked with a while back that took any type of ram > via a BIOS setting but that isn't what your talking about. > I'm guessing it's just not compatible. > Note that PC100 is <=10ns. 60ns isn't even PC66 IIRC. > I just don't think it will work. > > Maybe time to find someone to trade that ram for some EDO/FPM ECC ram... > > sim > > David Dyer-Bennet wrote: > > It says here "either fast page mode (FPM) or extended data out (EDO) > > 3.3V 60ns DRAMS mounted on JEDEC DIMMs". But just before that I may > > have found the actual problem -- "supports from 16MB to 1GB of ECC > > memory". I'll bet the ECC requirement is what I'm actually having > > trouble with. The other description I looked at didn't specify ECC. > > > > (It's the dual Pentium Pro motherboard in a Micron Vetix LXI-N server > > box; I *think* it's an intel BB440FX board actually. Anyway, it has 8 > > DIMM slots, each of which can hold up to a 128MB dimm.) > > > > _______________________________________________ > Twin Cities Linux Users Group Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >