I've installed zebra now instead. It has a nice cisco style config format. However, I can't make it broadcast routes at all. Doh... > -----Original Message----- > From: Bob Tanner [mailto:tanner at real-time.com] > Sent: Monday, February 04, 2002 8:33 PM > To: tclug-list at mn-linux.org > Subject: Re: [TCLUG] routed > > > Quoting Austad, Jay (austad at marketwatch.com): > > Does anyone have any experience configuring routed? > > > > I just need to be able to tell it the following things: > > > > 1. not to listen or advertise on one particular interface > (the public > > interface) > > 2. Not to advertise a particular network (the public one) > > 3. And to force it to advertise the network assigned to the > lo1 interface > > (it's actually a tunnel endpoint), I don't think it will by default > > advertise an address assigned as a loopback. > > > > > > I've tried using mrtd, but RIP support in it sucks, and I > can't make it > > advertise the network used for the tunnel. So, I'm > thinking routed should > > be fine. It's been around forever. > > Been a long time, but I used gated on Solaris. The main point > was gated (under > Solaris at least) support RIPv2, which is what you need if > you are subnetting. > -- > Minneapolis St. Paul Twin Cities MN | Phone : (952)943-8700 > http://www.mn-linux.org Minnesota Linux | Fax : (952)943-8500 > Key fingerprint = 6C E9 51 4F D5 3E 4C 66 62 A9 10 E5 35 85 39 D9 > > _______________________________________________ > Twin Cities Linux Users Group Mailing List - Minneapolis/St. > Paul, Minnesota > http://www.mn-linux.org > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >