On Tue, 2002-02-05 at 12:02, Chad C. Walstrom wrote: > Yep. You have to disable telnet from the enabled prompt. ;-) Open up > your owner's manual and read the instructions. ;-) If only I could *find* my documentation... Maybe I can download it from Cisco... > IIRC, it's something > like "set telnet disable". Got it. Thanks. I would also recommend setting the remote IP > as 127.0.0.1, just as an extra precaution. I don't trust Cisco much. > The 675/8 series has been known to have problems. I would also do the > same for the web interface. Even when the web interface is disabled, > your router still tries to answer HTTP requests. Set the web interface > remote IP to 127.0.0.1, and the port to something other than 80 or 8080. Did this way back when Code Red appeared. > Also, don't listen to Qwest tech support. They have no clue what > they're talking about. You'll rarely find a clueful person there, but > when you do, write down their name and extension. Keep it like the > treasure it is. Yes, so I have discovered. But at the time, he seemed to know what he was talking about, so I left it alone. Dave -- Beware the wrath of dragons, for you are crunchy, and good with ketchup. -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 232 bytes Desc: This is a digitally signed message part Url : http://shadowknight.real-time.com/pipermail/tclug-list/attachments/20020205/d0aa58a3/attachment.pgp