On another list there was an extended conversation on what to use for a hardware raid device. An inexpensive solution mentioned was the promise tx2 pro. If I can get it to work it will be a good choice for our church. On boot up I am able to create a mirror of two 30 Gig drives, but on install fedora sees both drives, hde and hdg. I wrestled with it for a while, but it seems the raid utility writes something to the hard drives that Linux doesn't like. I did go ahead with an install to see what would happen, and of course on a reboot the raid utility shows the mirror in a critical state, etc.... I broke the mirror and duplicated the drives, hoping it might somehow work, but it will not boot. If I boot to the cdrom and the install complains about two devices labeled /. Promise has a little bit of code available, but I am not sure how to put it to use on an install. Any ideas how to get past this? Raymond _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list