On Mon, 30 Jun 2003 09:18:36 -0500 Karl Bongers <kbongers at infinetivity.com> wrote: > I doubt that using an old card will fix it. 9600 baud serial > is the same on a old PC/8250 as it is on a new MB. You might > try configuring for 2 stop bits instead of just 1, problem is > most likely flow control(RTS/CTS, or XON/XOFF). Serial setings for the plotter are fixed with hardware switches on the back at 9600baud, no parity, 8 data, 1 stop. This is the same config used on the PC side previously & now. Why would setting a second stop bit on a known 1-stopbit line worK? -.bill.layer.- .-frogtown.mn.usa.- _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list