I have a redhat 8 server that I am trying to get a scsi HP dat 24G tape drive working on. At start up my Adaptec AHA-2940 card is found and shows scsi ID 7. If I go into the scsi utility it shows my tape drive on ID 2 as HP C1537a. Once the box boots I can see the card in the hardware browser under scsi devices. If I cat /proc/scsi I can only see my 3ware card. I do get an error in dmesg, but found other post on the net that seemed to think it was some issue about when modules get loaded. Not sure how to diagnose this further. Any help is appreciated. Raymond Dmesg shows SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 3ware Storage Controller device driver for Linux v1.02.00.025. scsi0 : Found a 3ware Storage Controller at 0xec00, IRQ: 10, P-chip: 1.3 scsi0 : 3ware Storage Controller Vendor: 3ware Model: 3w-xxxx Rev: 1.0 Type: Direct-Access ANSI SCSI revision: 00 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 80041216 512-byte hdwr sectors (40981 MB) sda: sda1 sda2 sda3 _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list