> Try doing a "modprobe st" and see if you can get it loaded into the > kernel. Then do an "lsmod" and look for the tape drive. I did "modprobe st" and then did "lsmod", and shazaam, it was all there! I am currently running a backup to the tape drive right now. Just wondering what would be the best way to be sure the Adaptec module was loaded on a reboot? <pertinent output of lsmod> Module Size Used by Not tainted aic7xxx 138484 1 3w-xxxx 33792 3 sd_mod 13552 6 scsi_mod 110344 4 [aic7xxx st 3w-xxxx sd_mod] </pertinent output of lsmod> < cat /proc/scsi> Attached devices: Host: scsi0 Channel: 00 Id: 00 Lun: 00 Vendor: 3ware Model: 3w-xxxx Rev: 1.0 Type: Direct-Access ANSI SCSI revision: ffffffff Host: scsi1 Channel: 00 Id: 02 Lun: 00 Vendor: HP Model: C1537A Rev: L105 Type: Sequential-Access ANSI SCSI revision: 02 </cat /proc/scsi> _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list