>From: Greg Brandow <grb at hvi.net> > >Does anyone know the correct SNMP OID to use to monitor >bandwidth usage on a Pipeline 130? Like all Ascend routers, the logical interface will change each time the interface comes up. Therefore, you'll need to chase it around. :-( Also, there are several interfaces: ie0 (Ethernet), T1 (which can have multiple Frame Relay interfaces) and the ISDN BRI B channels. So you need to know which profile is assigned to which interface, which you can ascertain with 'show ip route' or 'show ip address'. If you're using MRTG, you'll use... Target[pipeline130]: <interface#>:<community>@<router> If you're using numbered routing, you can use... Target[pipeline130]: <interface-IP-address>:<community>@<router> ...bearing in mind that when the logical interface moves, MRTG will complain until you edit mrtg.ok. HTH. -- Peter Lalor Infoasis plalor at infoasis.com http://www.infoasis.com/ "Where's my burrito?" -- Homer ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>