Thank. Point noted. I will try to recheck all parameters tomorrow. -----Original Message----- From: owner-ascend-users at max.bungi.com [mailto:owner-ascend-users at max.bungi.com]On Behalf Of Peter Lalor Sent: Tuesday, December 19, 2000 6:36 PM To: Danko Jevtovic Cc: ascend-users at max.bungi.com Subject: RE: (ASCEND) MAX to MAX connection > >First, the E1 layer. Are you seeing the E1 come up at all? We use T1, >>and I'm not sure of the specific differences (other than speed), but >>to cross one over just set up with the same signalling on each side >>and set one to Clock Source=Yes and the other to No. > >I seen all channels on E1 as nailed, and I have configured Clock Source >correctly. > >I use PPP (mulit link). On Wan stats only TX packets going out and >Connection profiles tries to connects, but fails with LCP timeout cause code >(like two units do not see each other). It should be straight PPP--not MP or MPP. This might be misleading you because you're using all the DS0s on the E1, but it's not actually multilink as far as the Maxen are concerned. -- Peter Lalor Infoasis plalor at infoasis.com http://www.infoasis.com/ "Where's my burrito?" -- Homer ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq> ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>