I had this problem with any code above 6.1.24 - so I dont use any code above that.. its a card reset issue. On Thu, 12 Apr 2001, Dennis Duval wrote: > > > Check to make sure your call is assigned to a modem and _not_ the HDLC > > controller! > > > > I've seen the same happen (Max 4004 and 4048) when a DS0 doesn't go to a > > modem slot card. > > > What settings should I check? I have each channel mapped to modem Slot 3. > I may not be understanding what you are suggesting. Again I stress that > all 4 lines are configured identically, and the problem only occurred on 2 > lines. All four lines on the 6096 had been working fine up until one > instant Monday night, when two lines went into total failure and did not > clear up until the lines were moved to a Max 4000 the next day. > > Dennis Duval > > > ++ Ascend Users Mailing List ++ > To unsubscribe: send unsubscribe to ascend-users-request at bungi.com > To get FAQ'd: <http://www.nealis.net/ascend/faq> > ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>