I'm pretty sure you can just point them to the first modem card slot and the calls will roll over to the next modem card slot when that one fills up. That takes out a little bit of the pain of settings things up initially. Phil On Sun, 08 Jul 2001, Troy Settle wrote: > > It's been nearly 6 years since I've had the (dis)pleasure of working with a > CT1, but here's what I remember: > > As indicated by your telco, set your channelized T1 to Inband, wink-start, > ESF, B8ZS. At this point, all 24 channels are up and in an idle state. > You're seeing when a call comes in, but the other side is recieving an 'all > circuits busy' message, which at this point, is being generated by your Max > because it doesn't know what to do with the call. > > What you need to do, is to go through and make your slot assignments for > each channel of the T1s to route the calls to an appropriate modem. If you > have 16-mod modems, then you'll assign the first 16 channels to slot 3, the > next 8 to slot 4. On the second T1, assign the first 8 channels to slot 4 > and the last 16 channels to slot 5. > > AFAIK, only with ISDN/PRI can you leave the slot assignmentes to slot 0 for > automatic call routing based on call type (analog or ISDN). > > -- > Troy Settle > Pulaski Networks > 540.994.4254 - 866.477.5638 > http://www.psknet.com > > > ** -----Original Message----- > ** From: owner-ascend-users at max.bungi.com > ** [mailto:owner-ascend-users at max.bungi.com]On Behalf Of > ** netlink at netlinkcorp.com > ** Sent: Friday, July 06, 2001 10:57 PM > ** To: ascend-users at bungi.com > ** Subject: Re: (ASCEND) MAX 6000 and a T1 > ** > ** > ** Rob Ctl = Inc-W-200 > ** and Clocking = Yes also might do the trick > ** so that the local telco does the clocking. > ** Do you have the signaling mode set to ISDN or Inband? > ** If you have it set to Inband I believe you need to set it to ISDN. > ** > ** Hope this helps. > ** ------- > ** R. Hall > ** NET-LINK Corp. > ** > ** > ** > ** Dennis Duval wrote: > ** > > ** > > company (SWBell) for the T1 settings, but only got > ** Wink-Start, ESF, and > ** > > B8ZS for info on how to setup my end. Ok fine. I do think > ** there is other > ** > > ** > I have some maxen hooked up to SW Bell and a Erickson slave > ** switch. I had > ** > to set my maxen to Wink-Inc-200 to get it to work. Might try > ** that instead > ** > of Wink-Start. > ** > > ** / > ** ++ Ascend Users Mailing List ++ > ** To unsubscribe: send unsubscribe to ascend-users-request at bungi.com > ** Archives: http://www.nexial.com/mailinglists/ > ** > ** > > ++ Ascend Users Mailing List ++ > To unsubscribe: send unsubscribe to ascend-users-request at bungi.com > Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/