Here is an excellent resource for AT commands for Lucent modems. Not only does it give the commands but a good explanation for what they do, what the readout is, and how to use them to troubleshoot modems. If you are looking to call via ISDN, the TNT uses HDLC drivers for digital calls.......not sure if you can use modems for this or if it is possible to "open" HDLC drivers for outgoing calls. http://www.lucent.com/micro/K56flex/v90atcom.pdf David Pascarella, MCSE CCNA A+ Network Support Engineer SOLUNET, Inc. 1571 Robert J. Conlan Blvd., Suite 110 Palm Bay, FL 32905-3562 888.449.5766 800.795.2814 fax: 321.308.7986 mailto:dpascarella at solunet.com -----Original Message----- From: Holger Steppke [mailto:Holger.Steppke at team4m.de] Sent: Tuesday, July 10, 2001 5:05 PM To: ascend-users at bungi.com Subject: (ASCEND) MAX TNT and at commands for the modem server Hi, do someone knows the valid AT commands that i can use during a connect via TCP to a modem from the pool/server that i can configure in the terminal-server settings? I can us the modem to dial out as an anlogue call with "atdt12345" but im looking for commands where i can force the TNT to do an ISDN call ... should be possible as the modems can do both anyway. kind regards ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/