Eric, You have to specify the system-ip address under ip-glo if you are going to use an ethernet card other than the shelf-controller. Also, don't forget the default route statement. Mario Puras SoluNet Technical Support Network Support Engineer We don't make network products, we make them Work! Mailto:mpuras at solunet.com 888.SOLUNET (Canada) / 888.449.5766 (USA) -----Original Message----- From: Eric Larsen [mailto:eric at istal.com] Sent: Wednesday, May 23, 2001 7:31 AM To: ascend-users at max.bungi.com Subject: (ASCEND) directing traffic over new ethernet card Does anyone know how to redirect traffic out over an ethernet-2 card rather than letting it go out through the shelf contoller. I put in a new ethernet-2 card, however, a netstat -i indicates that all data is still going through the ethernet port on the shelf contoller card. Any advice on how to fix this would be appreciated. Eric Larsen IST, Inc. ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/