Hi All,
I was hoping someone can share some light on this issue. I am working
with NavisRadius trying to get this outbound call established with CHAP.
Prior to bringing Radius into the picture, I set up a connection profile on
the Max to dialout to the remote router using Bi-Directional CHAP required.
That connection profile works well and I can establish an outbound call and
negotiate Bi-directional CHAP authentication. I brought NavisRadius into
the picture to achieve the same thing as what I did on the local connection
profile. I started on Navis by just getting the connection to dialout
without any authentication which I got it to connect and pass traffic. Once
I configure bi-directional CHAP in Radius, I see the call going out and the
CHAP handshake process going except that when the remote router send me his
CHAP packet type 3 (success) stating that they authenticated my response
successfully, the Max immediately send a termination Request and takes the
link down before sending out a CHAP packet type 3 to the remote router as it
did with the connection profile on the Max. I have pasted the dialout
profile below (Changing a few string before posting it). Can someone point
out to me what I am missing? Has anyone done this before? I have read the
Lucent manuals and their example does not work.
dialout
User-Name = "remote"
Service-Type = Outbound-User,
Framed-Protocol = PPP,
Ascend-Route-IP = Route-IP-Yes,
Framed-IP-Netmask = 255.255.255.255,
Ascend-Bi-Directional-Auth = Bi-Directional-Auth-Required,
Ascend-Recv-Name = "remote",
Ascend-Receive-Secret = "secret",
Ascend-Send-Auth = Send-Auth-CHAP,
Ascend-Authen-Alias = "mymaxname",
Ascend-Send-Secret = "secret",
Ascend-Data-Svc = Switched-modem,
Ascend-Idle-Limit = 1800,
Ascend-Maximum-Call-Duration = 120,
Filter-Id = "1",
Ascend-Call-Filter = "ip out forward"
Thanks,
Mario Puras
SoluNet