Three protocols are supported on the FrameLine card: Frame Relay, HDLC, and PPP. The FrameLine card does not support MP or MPP. You can have only one nailed group per T1 port. - David -----Original Message----- From: MPuras at solunet.com [mailto:MPuras at solunet.com] Sent: Friday, February 08, 2002 10:25 AM To: ascend-users at max.bungi.com Subject: (ASCEND) Multilink PPP on TNT Has anyone done ML-PPP on TNT's before? Is it even supported on the TNT's? I know ML-FR is but not sure about ML-PPP. Thanks, Mario Puras SoluNet Technical Support Customer Support Engineer -----Original Message----- From: shawn everett [mailto:everett at pgweb.com] Sent: Monday, February 04, 2002 3:36 PM To: ascend-users at max.bungi.com Subject: (ASCEND) Power-On Self Test FAILURE (05) I have a max 4000 that boots up and works for a few minutes before generating the above message. A search on google and deja for this message show nothing. I have tried using nvramclear to reset the unit but the problem persists. Any advice or suggestions would be apreciated. Shawn ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/