Hi, have you switched on to chain the pools ? Not sure about on a MAX from my head but at least on a TNT you have to chain them in the ip-global profile. Bye Holger >-----Original Message----- >From: rte-ascend-admin at lists.real-time.com >[mailto:rte-ascend-admin at lists.real-time.com]On Behalf Of Rob Carr >Sent: Tuesday, January 22, 2002 6:15 PM >To: rte-ascend at lists.real-time.com >Subject: re: [Ascend] 4048 only using first ip pool. > > >Tom, >I think the problem stems from the fact that you >haven't told the Max that it should use multiple >pools. When I looked up multiple pools in the RADIUS >manual, it seemed that if the Max did not have any >instructions on which pool to use, it would default to >the first pool (or if it was given instructions to use >a pool without addresses or one that was unconfigured >it would also default to the first pool). Try adding >a pool attribute to your user profile(probably >Ascend-IP-Pools=0) and setting it to zero, which >should get the Max to refer to it's configuration for >any available IP pool. > >Good Luck, >Ex-Escalation TNT/MAX Group Lucent/Ascend >Anybody in Seattle want to give me a job? > >>I have 2 maxes running 7.0.3. When I have more than >>one ip pool set up (Ethernet->Mod Config->Wan >>Options), the max will not go to the second or third >>ip pool once the first one's ip's are all in use. I >>just connects, doesn't assign an ip address, and >>hangs up. >> >>Due to a limited ip space and bad initial planning, >>I have these pool set up on one of the maxen: >>start - 1.2.3.96 count - 31 >>start - 1.2.3.21 count - 9 >>start - 1.2.3.40 count - 6 >>It only offers ip addresses out whichever poll is >>listed first. I am using 0-126 ip addresses for >>basically all of my ISP stuff (router, servers, >>maxen), so there all on the same segment. I have >>switched configurations between the two maxen, and >>the problem follows the configuration. >> >>My radius users file simply has: >>DEFAULT Password =3D "UNIX" >> User-Service =3D Framed-User, >> Framed-Protocol =3D PPP, >> Ascend-Idle-Limit =3D 900 =20 >>I have searched everywhere and have not found one >>instance of this happening elsewhere. >> >>Anyone have a suggestion on this? (besides >>renumbering all my devices and servers?) >> >>Thanks, >> >>Tom Coltharp >> >>PS - occasionally, for some reason, under some >>configurations, the second poll gets used. Once I >>try to add the third pool, it reverts to the first >pool. > >__________________________________________________ >Do You Yahoo!? >Send FREE video emails in Yahoo! Mail! >http://promo.yahoo.com/videomail/ >_______________________________________________ >rte-ascend mailing list >rte-ascend at lists.real-time.com >https://mailman.real-time.com/mailman/listinfo/rte-ascend >