i have a max tnt that is currently working fine
here is setup - 2 t1 cards, 7 48 port modem cards, 1 sdsl card, 1 4 port
ethernet card
have 14 pri's and two ethernet connections
right now tnt is on lan 1 - xxx.xxx.xxx.1, gateway is xxx.xxx.xxx.2 (no other
routes) and has two dial up pools xxx.xxx.66.1 (254 addresses) and
xxx.xxx.67.33 (200 addresses). gateway is cisco 2610 that has all networks
routed to tnt. ethernet port for system-ip -addr in ip-global is ip-interface
{{1 4 1}0}
trying to switch to a new network with system-ip-addr of yy.yy.yy.3, gateway
of yy.yy.yy.1 (cisco 3640) ip-interface {{1 4 2}0}, pools of yy.yy.yy.10
(240) and yy.yy.38.1 (200). I setup the ip-interface and can ping that
remotely, changed the default gateway, changed the system-ip-addr and pools
in ip-global, reset the tnt and it just isnt working. dial-up users can dial
in and get an address but can only ping the tnt - can go nowhere else. from
the console in the tnt i can ping anything - inside or out. but from outside
i cannot ping the dial-up users.
any help would be appreciated.
--
Chad Whitten
Network/Systems Administrator
neXband Communications
cwhitten at nexband.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request at bungi.com
Archives: http://www.nexial.com/mailinglists/