CTRL-BREAK (same as the pause key) If that doesn't work, you may need to search google for 'ascend' and 'nindy' for the jumper instructions. As I said, I've not done this on a 6000 before, but seem to remember that the break sequence will do it. Good luck, -- Troy Settle Pulaski Networks 540.994.4254 - 866.477.5638 http://www.psknet.com ** -----Original Message----- ** From: Ken Ross [mailto:ross at hotkey.net.au] ** Sent: Monday, March 11, 2002 5:32 PM ** To: ascend-users at bungi.com ** Cc: Troy Settle ** Subject: Re: (ASCEND) MAX6000 problem. ** ** ** Troy, how do I send a break to the MAX with Hyperterminal. What ** is the key ** combination for a break. ** I've tried using the CTRL key with every other key and other ** than refreshing ** the display, nothing else happens. ** ** Cheers ** Ken ** ----- Original Message ----- ** From: "Troy Settle" <troy at psknet.com> ** To: "'Ken Ross'" <ross at hotkey.net.au>; <ascend-users at bungi.com> ** Sent: Monday, March 11, 2002 6:43 PM ** Subject: RE: (ASCEND) MAX6000 problem. ** ** ** ** I'm not 100% sure of this, but it sounds like the software image is ** corrupt. If this is the case, you'll need to NINDY the box and reload ** the software image. I've only done this on a 4000 box, which requires a ** jumper setting. ** ** IIRC, the 6000 series will enter NINDY by sending a break during POST. ** If this doesn't work, hopefully someone else on the list can help out ** before you get stuck calling Lucent for support. ** ** If you do do a NINDY, you'll need a terminal emulator capable of xmodem ** file transfer. Hyperterm works fine, as does CRT. ** ** Good luck, ** ** -- ** Troy Settle ** Pulaski Networks ** 540.994.4254 - 866.477.5638 ** http://www.psknet.com ** ** ** ** > -----Original Message----- ** > From: owner-ascend-users at max.bungi.com ** > [mailto:owner-ascend-users at max.bungi.com] On Behalf Of Ken Ross ** > Sent: Monday, March 11, 2002 12:38 AM ** > To: ascend-users at bungi.com ** > Subject: (ASCEND) MAX6000 problem. ** > ** > ** > I hope that one of you knowledgeable people can shed some light on my ** > problem. ** > I have a MAX 6000 (only about 14mths old) that when switched on, goes ** > through its POST diagnostic OK but when it prompts to ' Press ** > any key', ** > nothing happens and about a minuite later it will reboot ** > again and will ** > continue this cycle until its switch off. ** > Can anyone help with this problem. ** > ** > TIA. ** > ** > Ken Ross ** > ** > ++ Ascend Users Mailing List ++ ** > To unsubscribe: send unsubscribe to ** > ascend-users-request at bungi.com ** > Archives: http://www.nexial.com/mailinglists/ ** > ** > ** ** ** ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/