If you have two MAX3000 behind the router, the router needs to know which addresses are in use by each MAX. The range cannot be shared unless you use a dynamic routing protocol like RIP or OSPF. >We cross checked this option but router know about the IP pool given to Max >dial in users...we are using one class c pool and one router as our >gateway...so I dont think that can be the problem. >Any other clue?? > > > Chances are that the next router after the MAX doesn't know > > about the IP address of the dialin users. > > > > > > > > > >Hello All! > > >I am having strange problem. Just bought Max3000 with Software +9.1.2+ > > >loaded on to it. Client get connect to the terminal easily but ping > > request > > >gives Request Time Out and Traceroute also does not give any responce. > > >Why this is happening. No filter is installed on the machine. > > >I got one more max3000 machine with Software 9.0.2+ installed on it is > > >running with out any problems. Client do get ping responce as well as > > >Traceroute responce. > > >I compared new max3000 config with old one all the same...cannot figure > > out > > >what is wrong. One more clue is if I telnet the machine and ping the > > remote > > >site then I get responce easily. > > >Any help ??? > > > _________________________________________________________________ Chat with friends online, try MSN Messenger: http://messenger.msn.com ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/