Thanks for the replies Troy.. I'll check these out soon. The reason i am moving away from the idea of redirecting the traffic on router is the high CPU utilization factor of the router. I am already running such a setup. Anywya.. lets see wht can be doen with the TNT Thanks once again ----- Original Message ----- From: "Troy Settle" <troy at psknet.com> To: "'Faisal S. Naik'" <faisal at hamdard.net.pk>; "'Ascend-users'" <ascend-users at max.bungi.com> Sent: Friday, November 22, 2002 4:56 PM Subject: RE: (ASCEND) TNT config-commands > > > -----Original Message----- > > From: owner-ascend-users at max.bungi.com > > [mailto:owner-ascend-users at max.bungi.com] On Behalf Of Faisal S. Naik > > Sent: Friday, November 22, 2002 12:40 AM > > To: Ascend-users > > Subject: (ASCEND) TNT config-commands > > > > > > Hello All, > > I need to monitor the modem success rate and call success rate for all > > incoming user calls on my TNT. Is there a specific command to > > check this or > > do i need to enable some debug? > > > > The best way to do this, is via radius and/or syslog accounting. I've > set my radius server to record all accounting data to a SQL server, from > which, I can quickly generate reports on connect speeds, disconnect > causes, connection failures, etc... In order to see failed connection > attempts, you'll need to set > external-auth/rad-acct-client/acct-stop-only = yes. > > > > 2ndly what type of message do i need to enable for syslog messages to > > display E1 link down messages on my syslog server. > > Log/syslog-level = critical > > If you have an SNMP server, you can enable trap messages, which should > be more efficient than scanning syslog for such issues. > > > > > And finally i need to define policy routing on the TNT box to > > redirect all > > port 80 traffic to my proxy server forcefully, how to go about it? > > I don't know if you can set up a port redirect in the TNT, but I do know > that you can set up filters to block port 80 traffic to anything except > your proxies (which is a good idea in general). The only drawback to > this, is that your users will need to manually set their proxy server > address. > > I would recommend either setting your proxy server between the TNT and > border router, or do the redirect on the border router itself (there's a > sample configuration in the Squid FAQ and/or manual (which would apply > even if you're not using squid). > > > > > TIA > > > > Regards, > > ----------- > > Faisal §. Naik > > Karachi. > > I hope this helps, > > -- > Troy Settle > Pulaski Networks > 540.994.4254 - 866.477.5638 > http://www.psknet.com > ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/