Dear Ascend helpers DPascarella at solunet.com schrieb: > > Max 4000 HP > > . With all cables and power removed remove all cards from the box, open the > case and > orient the LEDs toward you (the front). > . Locate P3 and short it. > . Attach the serial and power cables. Power up at 57600 N-8-1 no > flow-control > . At the > prompt enter DF then upload the correct version of firmware. Down > load the > software using Xmodem 57600-N-8-1 no flowcontrol. > . Power down the unit, remove the jumper from P3 and put the cover back on > . Reconfigure the terminal/serial connection for 9600 and configure the Max, > or use the > configurator. > > Max4000 > > . With all cables and power removed remove all cards from the box, open the > case and > orient the LEDs toward you (the front). > . Locate P6 and short it. > . Attach the serial and power cables. Power up at 57600 N-8-1 no > flow-control > . At the > prompt enter DF then upload the correct version of firmware. Down > load the > software using Xmodem 57600-N-8-1 no flowcontrol. > . Power down the unit, remove the jumper from P6 and put the cover back on > . Reconfigure the terminal/serial connection for 9600 and configure the Max, > or use the > configurator. > it worked, the problem is solved, tanx to all repliers! Best regards Charly -- Karl Gaissmaier Computing Center,University of Ulm,Germany Email:karl.gaissmaier at rz.uni-ulm.de Network Administration Tel.: ++49 731 50-22499 ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/