I was running the 2.1 release, IPv6 is good for tunneling and basic setups, but it was unusable in bridged mode with an existing radvd. I think it was a firewall rule issue, but after trying for a few days, I just gave up. I was using a Atheros based wireless chipset that didn't have drivers until FreeBSD 9.x, and I believe pfSense is still 8.2 based. Card was recognized, but I couldn't assign addresses or bring it up. Other cards might behave nicer, just my experience. Bought a B/G card that's been running fine since then, but rebuilding with Linux will let me use the B/G/N. On 01/14/14 13:45, Ryan Dunlop wrote: > I also use pfSense at home and work. At work it's virtualized (ESXi) and > at home it's on a netgate device. Runs great on very little hardware. > > IPv6 has been up and running stable on 2.1 (was doable before then but now > it's fully implemented). Wireless N is up to the BSD folks to get drivers > set, although a B/G/N card will be recognized it won't run at N speeds. All > the goods Erik points out and my OpenVPN tunnels stay stable forever if > needed on very low specs. Highly suggest checking it out. > > > On Tue, Jan 14, 2014 at 1:41 PM, Erik Anderson <erikerik at gmail.com> wrote: > >> On Tue, Jan 14, 2014 at 1:38 PM, Ryan Coleman <ryanjcole at me.com> wrote: >> >>> Hmm. Can you send a link to this hardware? >>> >> >> It's this one: >> >> http://soekris.com/products/net5501.html >> >> I got the -60 model, which has 256MB RAM and a 433MHz CPU. >> >> >> _______________________________________________ >> TCLUG Mailing List - Minneapolis/St. Paul, Minnesota >> tclug-list at mn-linux.org >> http://mailman.mn-linux.org/mailman/listinfo/tclug-list >> >> > > > > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota > tclug-list at mn-linux.org > http://mailman.mn-linux.org/mailman/listinfo/tclug-list >