Hi, I am exploring options to use MAX4060/4*E1 not only for dial-in but also for POP to CO connectivity. Currently I am using them for 2*PRI dial-in (full 60 channel load). Will it be able to handle additional load for nailed circuit (either E1 or serial)? I tried to establish direct crossover cable E1 to E1 connection but without success. I have found document on esight.com explaining T1-T1 connection but I was not able to do same thing with E1. What Signaling mode, Switch type and Framing mode should I use. Are there any special considerations for Connections and Answer profile. My other plan is to use frame relay on synchronous serial port with V35. Can it be done and are then any compatibility or performance issues? Thanks for suggestions, regards, Danko Jevtovic ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>