Tim wrote: > Is there something special I need to do to make routes from the dial-up > pool and static routes from RADIUS advertised via OSPF? We are running > 7.2.x. I can see the OSPF neighbors and it is picking up routes from > other routers fine but it doesn't seem to be advertising any routes. We > have a single backbone area so one would think it should be > straightforward. I put in static routes in our Cisco router right now > but it's been pretty aggravating. Some of the settings follow: > > new ospf-area-range > set area-network-addr = 192.168.58.9/26 > set area-network-mask = 255.255.255.192 > set advertize = yes > > new ip-global > set pool-summary = yes > set pool-ospf-adv-type = type-1 > set ospf-pref = 10 > set ospf-ase-pref = 150 > set ospf-global as-boundary-router = no > > new ip-interface > set interface-address physical-address shelf = shelf-1 > set interface-address physical-address slot = slot-3 > set interface-address physical-address item-number = 1 > set ospf active = yes > set ospf area = 0.0.0.0 > set ospf area-type = normal > set ospf ase-type = type-1 We have exactly the same problem and have no idea so far. :-( Did anybody successfully configure OSPF between a Lucent TNT and a Cisco Network? Regards, -- Oliver Stettner | mailto:os at landshut.org Laendgasse 120 | http://www.landshut.org/members/os/ D-84028 Landshut | ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>