Hi, Do you or anyone else have any APX8-SL-96DSP cards available for sale? Thank you, Tom Ryder RYDER Communications, Inc. Wide Area Networking Solutions 35B Wilson Drive Sparta, NJ 07871-3427 Tel. 973-940-7350 / 1-877-RYDRCOM x222 FAX. 973-940-7355 / 1-877-RYDRFAX tom at rydrcom.com www.rydrcom.com -----Original Message----- From: rte-ascend-admin at lists.real-time.com [mailto:rte-ascend-admin at lists.real-time.com]On Behalf Of Nicholas Sten Sent: Wednesday, January 09, 2002 12:26 PM To: Mark Frater; rte-ascend at lists.real-time.com Subject: Re: [Ascend] voice using csm3v-card Not according to some of the documentation. The only cards that support voice are: TNTV-SL-ADI-C (48-port MultiDSP cards) APX8-SL-96DSP (96-port MultiDSP cards) Furthermore, the following should be noted. * You can mix the 48-port and 96-port MultiDSP cards in a single chassis for data applications only (v.90, ISDN, VPN, etc.) but not when running VoIP. * The 96-port MultiDSP will only support G.711 and G.729a * The 48-port MultiDSP supports the following codecs: G.711, G.729a, G.723.1, G.728, and RT-24 This information was obtained from "Frequently Asked Questions - TAOS 9.0 for MultiVoice", PDF filename 139912_FAQ.pdf I'm in the same boat, with a truckload of csm3v's that I had anticipated way-back-when would be the card. I don't suppose you have any old documentation that said it would be able to support voice, do you? -Nick At 09:31 AM 1/9/2002 +1300, Mark Frater wrote: >Apparently the csm3v-card was going to be the card with the new DSP on it >that Lucent were going to use for voice. Instead they came out with the MADD >cards. > >Anyone know if its possible to "do VOIP" with a csm3v-card? > >Mark > >_______________________________________________ >rte-ascend mailing list >rte-ascend at lists.real-time.com >https://mailman.real-time.com/mailman/listinfo/rte-ascend _______________________________________________ rte-ascend mailing list rte-ascend at lists.real-time.com https://mailman.real-time.com/mailman/listinfo/rte-ascend