having some trouble getting this working on cisco serial 0/0 ip address 192.168.4.1 255.255.255.252 ! ip route 208.x.x.0 255.255.255.128 192.168.4.2 on pipeline (6.1.7 taos) here are the settings I changed, everything else is default or NA configure > switch type = AT&T/P-T-P chan usage = Leased/Unused Ans Voice Call = No My Name = pipeline My Addr = 192.168.4.2/30 Rem Name = cisco Rem Addr = 192.168.4.1/30 Route = IP Bridge = No ethernet > connections Station = Cisco Active = Yes Encaps = PPP Route IP = Yes Bridge = No IP Options > LAN Adrs = 192.168.4.1/30 ethernet > static routes > default Active = Yes Dest = 0.0.0.0/0 Gateway = 192.168.4.1 ethernet > mod config > ether options IP adrs = 192.168.4.2/30 2nd Adrs = 208.x.x.1/25 RIP = Off RIP2 Use Multicast = No Ignore Def Rt = Yes Proxy Mode = Off Filter = 0 IPX Frame = None now i get no rx packets on the wan link on the pipeline and on the cisco i get t1 is up, line protocol is down. the pipe is trying to connect to the cisco, but the call is terminated each time. right now, this is not going through a live t1 but rather just a t1 crossover cable here in my office (which I have used to connect cisco's back to back before so i know the cable is good) -- Chad Whitten Network/Systems Administrator neXband Communications cwhitten at nexband.com ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request at bungi.com Archives: http://www.nexial.com/mailinglists/